|
|
|
Ametes Angle Sensor Module, 360ASMF Series
 |
| |
 2SA-10
with GMW360A Angle Sensing Evaluation Kit - AN_360KIT
The AN_360KIT enables immediate evaluation of the
Sentron 2SA-10 Two-Axis Hall IC with the GMW360A Interpolator
IC. It generates Analog Linear and PWM signals proportional
to the angle of rotation of a small permanent magnet over
a full 360 degree rotation. Resolution is better than
one degree. Provision is included for setting the electronic
zero at any mechanical angle. (The 2SA-10-SO with GMW360A
is also available packaged as the Ametes 360ASM
Angle Sensor Module.)
AN_360KIT
Data Sheet - pdf, 1,215kB
|
 The 360ASM-01 is no longer in production see Discontinued Products.
360ASM Angle Sensing Module Evaluation Kit - AN_360ASMKIT
Quickly evaluate the Ametes 360ASM
Angle Sensor Module for non-contact, 360°, angle sensing applications. The 360ASM combines the Sentron 2SA-10 Two-Axis Linear Hall sensor with the GMW360A Sin/Cos to Analog Interpolator to accurately measure the angle of the magnetic field generated by a small permanent magnet. An analog 2.5V±2.0V signal is available corresponding to 0 ±180° rotation angle. Mechanical adjustment for zero angle is eliminated by having the electrical zero settable to any angle. The Kit includes a small PCB (28x13mm, 1.1x0.5inch) with a connector for the 360ASM, 360ASM Module, and a Rotary Holder with Permanent Magnet.
AN_360ASMKIT
Data Sheet - pdf, 221kB
|
Permanent Magnet for Angle Sensing - 55B0082
A 6.35mm dia. x 3.81mm SmCo permanent magnet that is polarized
across its' diameter rather than axially. Compatible with
the 2SA-10 and may be mounted into the M250-1.0 Magnet
Holder (shaft).
55B0082 Outline Drawing - pdf, 19kB
|
Permanent Magnet for Angle Sensing - 55C0126
A 6.35mm square x 2.55mm thick SmCo permanent magnet that is polarized
across its' width rather than depth. Compatible with
the 2SA-10.
55C0126 Outline Drawing - pdf, 18kB
|
Magnet Holder and Magnet for Angle Sensing - M250-1.0
The M250-1.0 is an aluminium holder with a 6.35mm diameter
shaft that is 25.4mm long. It comes with a 55B0082 permanent
magnet epoxied into one end of the shaft.
M250-1.0 Outline Drawing with magnet - pdf, 79kB
M250-1.0 Outline Drawing without magnet - pdf, 44kB
|
Magnet Holder and Magnet for Angle Sensing - M250SQ-1.0
The M250SQ-1.0 is an aluminium holder with a 6.35mm diameter
shaft that is 25.4mm long. It comes with a 55C0126 permanent
magnet epoxied into one end of the shaft.
M250SQ-1.0 Outline Drawing with magnet - pdf, 42kB
M250SQ-1.0 Outline Drawing without magnet - pdf, 41kB
Last updated on
23 September, 2008
|
| Back
to Top |
|
|
|
|
|
