 The Standard CryoSaver™ leads use a fiberglass composite body to encase the HTS wire for structural integrity. Nickel plated
copper endcaps are used for warm and cold end connections. Standard lead models are listed below (see diagram for dimensional
information). Shorter versions of the Standard lead design are also available, with an overall length of 170mm and a typical increase in
heat leak of around 75% compared to Standard leads.
Designed for service in cryogenic liquid or vapor, CryoSaver™ Hermetic leads utilize a thin-walled stainless steel outer body and lid to
form a hermetic seal against absorption of helium into the HTS wire. Mounting point center to center and overall length are the same
as equivalent Standard leads (see diagram above).
|
| Standard CryoSaver Current Leads Specifications |
| Part Number |
CS010030 |
CS025030 |
CS050030 |
CS100030 |
CS200030 |
Units |
Operating Current
(at 64K) |
100 |
250 |
500 |
1000 |
2000 |
A |
| Body Diameter A |
0.375
(9.53) |
0.438
(11.3) |
0.563
(14.30) |
0.750
(19.05) |
1.00
(25.4) |
inches
mm |
| Dimension B |
0.13
(3.30) |
0.25
(6.35) |
0.25
(6.35) |
0.375
(9.53) |
0.438
(11.13) |
inches
mm |
Conductive Heat Leak
(at 64k-4.2K per pair) |
32 |
76 |
145 |
285 |
480 |
mW |
| CryoSaver Hermetic Current Leads Specifications |
| Part Number |
CSH010030 |
CSH025030 |
CSH050030 |
CSH100030 |
CSH200030 |
Units |
Operating Current
(at 64K) |
100 |
250 |
500 |
1000 |
2000 |
A |
| Body Diameter A |
0.375
(9.53) |
0.438
(11.3) |
0.563
(14.30) |
0.750
(19.05) |
1.00
(25.4) |
inches
mm |
| Dimension B |
0.13
(3.30) |
0.25
(6.35) |
0.25
(6.35) |
0.375
(9.53) |
0.438
(11.13) |
inches
mm |
Conductive Heat Leak
(at 64k-4.2K per pair) |
Please Ask |
Please Ask |
Please Ask |
Please Ask |
Please Ask |
mW |
| Specifications
are subject to change without notice. |
For more information regarding HTS-110 Current Leads,
please contact Ian
Walker. |
