| |
 Ultrastab Saturn Current Transducers are single channel systems, including the Transducer Head, Electronics Control, Programming Plug (range to be specified), Transducer Head Connecting Cable, Analog Output Cable, User Manual, and Calibration Certificate.
The Ultrastab Saturn Current Transducers has a DC to 500kHz bandwidth with a 0.01ppm resolution and an absolute calibration traceable to NIST. Order part numbers for standard systems:
SAT-600U - Current Transducer, 1 channel, 600A/25mm/20A, 10m transducer head connecting cable, 5m signal output cable, ±10V output.
SAT-2000U - Current Transducer, 1 channel, 2000A/50mm/125A, 10m transducer head connecting cable, 5m signal output cable, ±10V output.
SAT-5000U-140 - Current Transducer, 1 channel, 5000A/140mm/250A, 10m transducer head connecting cable, 5m signal output cable, ±10V output.
SAT-600I - Current Transducer, 1 channel, 600A/25mm/20A, 10m transducer head connecting cable, 5m signal output cable.
SAT-2000I - Current Transducer, 1 channel, 2000A/50mm/125A, 10m transducer head connecting cable, 5m signal output cable.
SAT-5000I-140 - Current Transducer, 1 channel, 5000A/140mm/250A, 10m transducer head connecting cable, 5m signal output cable.
|
Programming Plugs are used to program the current range of the Current Transducer. This plug
sets the ratio between the current measured and the output signal of the transducer head.
SAT-PP - Programming plugs for the SAT-600/2000, specify fs current.
SAT-PP - Programming plugs for the SAT-5000-140, specify fs current
|
Transducer Head Connecting Cables are for used between the Saturn Control and transducer head. Standard lengths is 10 meters; optional lengths include 5, 10, 20 and 30 meters .
|
 16900451 Primary Current Cable for DC or AC measurements to 500A rms. These cables are constructed
using three flexible cables terminated in a lug.
These cables allow 'splitting' of the return current around
the transducer, reducing the radiating loop area and improving frequency response.
Additional Data:
Drawing: 16900451
Revision B - PDF - 78kB
|
 199080011 Cable Kit is for DC or AC measurements to 1,500A rms. The cables are constructed
using four flexible cables with lugs. Plates on each side of the head locate the cables approximately, symmetrically around the head to reduce the radiating loop area and and improve frequency response.
|
 Busbars are for DC measurements to 2,000A. Busbar is a solid bar with locating o-rings. Current cables are connected to each end.
SAT-BB-600 - Busbar for 600A transducer head
SAT-BB-2000 - Busbar for 2000A transducer head
|
 Signal Output Cables are user modifiable for use with either low or high impedance loads or current output, standard length 5 meters.
SAT-OC-I-1.5m - Cable, analog, current output, 1.5m
SAT-OC-I-5m - Cable, analog, current output, 5m
|
|
|
|
